You can also use a towel as a cushion if you have an expensive or fragile watch. While you can do this with the watch in your hands, you will find placing the watch on a flat surface more comfortable and efficient. You can even use duct tape wrapped around a tennis ball with the sticky side out if you cannot get a rubber ball. Along as the ball is not made from hard materials, it should work. You can even use stress back for this purpose. Most rubber balls can easily hold on to the back plate long enough for you to pry them off. You will need a soft, pliable, tacky rubber ball. If the watch uses a screw-back design, you can just use a rubber ball to remove it. Using a Rubber Ball on a Screw-Back Watch Source: Otherwise, you could break both your thumb and the watch. If the back does not come off easily, you should try another method. With pressure and patience, the back should come off the watch. The watch should rest in your other hand while you do this, and should never try harder than you need to avoid breaking your nail. Either way, you do this by pushing your nail into the crack and try to pry it open. Otherwise, you can use any point on the back you can reach. If the watch has an indentation for the hinge, you should focus your efforts on it. The only real restriction is that the watch cannot have screws holding the back to the case. On cheap, simple watches, your thumbnail is the perfect tool. Here are a few of these methods you could try to remove the back from your watch. However, you can still open a few watch styles even if you do not have a good knife around. The above method will work with most watches with or without a notch. When that happens, you can remove the watch from the clamp and use the knife to pry the back off the watch. With enough pressure, the back will separate from the case. With your fingers above the knife, gently push the knife down with the palm of your hand. You do this by inserting the edge against the break between the back and the case. With the watch secured, you can then use the knife to pry off the backplate. There should be just enough room so the watch back to come off. The watch should stay loose but firm as you tighten the clamp around it so you do not break the crystal. You want the watch situated perpendicular to the clamp and table with the exposed side up. Also, a small kitchen knife will work if you do not have a razor blade.Īfter wrapping the cloth around three sides of the watch, you can place it within the clamp on your table. You will just need to take more precautions to not break the watch. You want a clamp that has padded ends, but any clap will do. How to Open Your Watchįor most watches, you will just need a six-inch woodworker’s clamp, a sharp penknife, a piece of cloth, and a table. You can exploit this difference to open watches without back notches. Fortunately, most watches have a height difference between the backplate and the watch case. More often than not, today’s watches have no notch, raised lip, or pry area. Though it makes fashion sense to have this, it becomes an issue when you must replace the battery or fix something inside. To that end, modern watches use battery-powered mechanics with sleek, smooth designs. While they no longer have a utility purpose in these days of smartphone proliferation, a good watch still holds great value in fashion. We may receive a commission for purchases made through these links." "This site contains affiliate links to products.
0 Comments
Leave a Reply. |